VIDEO

Informace

Dodge

Dodge B17E5

See the basic definition of a diagnostic error. This will help you to clarify the main causes of the fault code. You will understand the program of the control unit
Basic DTC analysis according to OBD2 protocol standard.

OBD2 or On-Board Diagnostics displays messages for basic group styles. More comprehensible code composition has been standard since 2000. The DTC code consists of five characters and its composition will be shown in this video

Insight into programming

The basic unit for the operation of any computer is the bit. Logic 0 and 1 are expressed by a single bit. Diagnostics The error code is composed of 16 bits. The first two bits define one of the four basic circuits. The video will show you a comprehensive overview of the composition of the error report

A diagnostically understandable description of the Diagnostic Trouble Code

Dodge B17E5

Basic error definition

Solenoid Circuit

Cause of DTC

The Transmission Control System uses five electronically controlled solenoids that allow hydraulic fluid to be applied to various friction elements (clutches), which enables the gear requested. The continuity of each solenoid circuit is periodically tested. Each inactive solenoid is turned on for a few milliseconds, then off. Each active solenoid is turned off for a few milliseconds, then on. This pulsing of voltage to the solenoid causes an inductive spike which is sensed by the Transmission Control System. If an inductive spike is not sensed by the Transmission Control System during the continuity check, it is tested again. If the test fails three consecutive times, the appropriate Diagnostic Trouble Code (DTC) is set. If the solenoid test is run in response to a gear ratio or pressure switch error, one failure will result in setting the appropriate DTC.