VIDEO

Informace

KIA

KIA B1910

See the basic definition of a diagnostic error. This will help you to clarify the main causes of the fault code. You will understand the program of the control unit
Basic DTC analysis according to OBD2 protocol standard.

OBD2 or On-Board Diagnostics displays messages for basic group styles. More comprehensible code composition has been standard since 2000. The DTC code consists of five characters and its composition will be shown in this video

Insight into programming

The basic unit for the operation of any computer is the bit. Logic 0 and 1 are expressed by a single bit. Diagnostics The error code is composed of 16 bits. The first two bits define one of the four basic circuits. The video will show you a comprehensive overview of the composition of the error report

A diagnostically understandable description of the Diagnostic Trouble Code

KIA B1910

Basic error definition

Vehicle Speed Sensor A

Cause of DTC

The monitor will run whenever these DTCs are not present: None Time after engine switch off to on: 3 seconds or more Engine: Running Battery voltage: 8 V or more Engine switch: ON Starter: OFF Either of the following conditions are met: Condition 1 or 2 1. All fo the following conditions are met: Condition (a), (b) or (c) (a) ECT: 60°F (20°C) or more (b) ECT fail: Not detected (c) Time after park neutral position switch ON to OFF: 10 seconds or more 2. All of the following conditions are met: Either (a) or (b) is set (a) ECT: Less than 68°F (20°C) (b) ECT fail: Detected (c) Time after park neutral position switch ON to OFF: 30 seconds or more